1. Use the hole at the top of the controller as a reference and secure a 1" (25 mm) screw into the wall. Note: Install screw anchors if attaching to drywall or masonry wall. 2. Align controller with the screw and slide the keyhole on top of the controller over the screw. 3. Secure controller in place by installing screws in the holes.
To reset the controller: Press and hold down the minus (-), right arrow (>), and PRG buttons. Press and release the reset button on the right side of the controller. Wait 2 seconds and release the minus (-), right arrow (>), and PRG buttons. The display should now show 12:00 am. All the memory has been cleared and the controller will now have Centralus: Irrigation Management Platform for ICC2 Controllers. We’re going to install a WIFIKIT to a Hunter ICC2 controller, connect it to a network, and set it up in the Centralus software control system. The popular and cost-effective ICC2 controller is now web-enabled to provide a range of powerful and flexible remote irrigation Step 1. Press the arrow (>) until the icon appears on the display. The number 1 will be flashing on the display. This represents the number of days between watering. "1" indicates watering every day, while "2" indicates watering every other day. In Interval mode, you have the option of watering up to once every 31 days. . 242 427 168 27 276 312 463 151